View Full Version : P1i Touchscreen Calibration Issue

05-06-2008, 05:49 PM
Hi all,

New here and desperate! A couple of days ago, the callibration on the display goes askew. I try callibrating again (control panel>setup wizard), but even that screen is not calibrated. After touching the flashing points 1 and 2, for point three i keep getting a message " too far from point3" every time i try. Essentially, I think the place to touch point3 has gone out of the display area.

I just upgraded the software using the SEUS, but the problem unfortunately still exists.

Ironically, I replaced my P910 because it had the exact same problem!!

I am a heavy touchscreen user and just navigating through the jog-dial and keyboard frustrates me hugely.

I appreciate any suggestions. Thanks in advance.

07-06-2008, 01:32 AM
Welcome in sign. Enjoy it!